Disc Sanders

 

  MODEL 20-SD

Specifications: Overall Dimensions: Width 29″, Depth 30″, Height 54″Table:  11″ x 27″, with 3 3/8″ x 4 ¾” projections beyond disc.Raises and lowers from 1″ below disc to 1″ below center of disc.Tilts 45 degrees up and down. Locks securely in any position.Table stop – 90 degrees positive and adjustable. Protractor has degree markings on sloping face. Table front edge machined parallel with disc and 3/8″ x ¾” groove.Hand tilt table standard, gear tilt optional at extra cost. Disc: 20″ dia. Cast aluminumHub: 6″ dis. Cast IronMotor: 2 or 3 HP; 3 phaseStarter:  Manual, magnetic or reversing

  MODEL 24SDP

Specifications:Overall dimensions: Width 38″, Depth 32″, Height 53″Table:  12″ x 31 ½”. Cast Iron surface ground. Tilts 45 degrees up or down.Gear tilt table and table elevating mechanisms are standard equipment.Guards above and below table.Disc: 24″ dia. Cast AluminumHub:  8″ dia. Cast IronMotor:  2, 3 or 5 HP; 3 phaseStarter:  Manual, magnetic or reversing

   

MODEL 30 SD

Specifications:Overall Dimensions:Width 46″, Depth 47″, Height 53″Table:  14″ x 38 ¼” plus 3 ¾” x 7 ¼” projections beyond disc.Normalized, fine grain cast iron, heavily ribbed, surface ground.Tilts 30 degrees up and 45 degrees down, using ball bearing mounted worm gear mechanism.  Gear tilt table and table elevating mechanisms are standard equipment. Front and both ends are machined. Top surface grooved 3/8″ x ¾”. Disc:  30″ dia. Cast aluminum completely machined, electronically balanced, ¾” thick at rim, 1″ thick at hub, centered by 10″ flangeto which it is attached by 4 studs. No holes in face of disc. Grinding can be done by resting work on table or “off-the-hand”. Hub:  10″ dia. Cast Iron Drive:  Multiple V-Belt. Main spindle runs on heavy duty, sealed, self aligning tapered roller bearings. Operating Speed:  1000 RPM or other specified speeds Base and Cap:  Heavy ribbed Cast Iron. Base: 32″ wide by 34″ deep.Bolt centers 28 ½: x 30 ½”. Motor: 5 or 7 ½ HP, 3 phase Starter:  Manual, magnetic or reversing